JCM800[ Studio Stack ] Preset name: JCM800[ Studio Stak ] Comments: Fully maxxed out jcm800....pre-Q'd and then run thru a full stack before running thru a sharply tuned studio Eq...lays into the mix very nicely..adjust amp gain using guitar Eq pedal output volume... Effects chain: Spoiler: Preset settings Effect: "Noise Reducer" (Dynamics / Filter), active - "yes" { "Sens" = 36"Mode" = Soft} Effect: "GuitarEQ" (Dynamics / Filter), active - "yes" { "160 Hz" = -1"400 Hz" = -1"800 Hz" = 4"1.6 kHz" = -1"3.2 kHz" = -1"6.4 kHz" = -3"12 kHz" = -5"Level (dB)" = -2} Effect: "Ms JCM800" (Amp simulators), active - "yes" { "Gain" = 100"Bass" = 100"Middle" = 100"Treble" = 100"Presence" = 100"Master" = 100"Level (dB)" = 0} Effect: "Splitter" (Dynamics / Filter), active - "yes" { "A-Bypass" = Off"A-Pan" = 0"A-Level" = 55"B-Bypass" = Off"B-Pan" = 0"B-Level" = 55 'A' branch: { Effect: "Guitar IRs Cab" (Cabinets), active - "yes" { "Model" = Marshall 1960A (4x12")"Mic Position" = Middle"Mic Distance" = Far"Low Cut (Hz)" = 98"Hi Cut (kHz)" = 4.0"Mix" = 100"Level (dB)" = 0} } 'B' branch: { Effect: "Guitar IRs Cab" (Cabinets), active - "yes" { "Model" = Marshall 1960b (4x12")"Mic Position" = Middle"Mic Distance" = Far"Low Cut (Hz)" = 89"Hi Cut (kHz)" = 4.0"Mix" = 100"Level (dB)" = 0} } } Effect: "Studio EQ" (Dynamics / Filter), active - "yes" { "31 Hz" = -15"62 Hz" = -11"125 Hz" = -1"250 Hz" = -7"500 Hz" = -4"1 kHz" = -9"2 kHz" = -1"4 kHz" = 1"8 kHz" = -12"16 kHz" = -12"Level (dB)" = 0} Effect: "HD Chamber Rvb" (Reverberation), active - "yes" { "Time" = 3.4"PreLPF" = 64"PreDelay" = 142"HiDamp" = 50"LoGain" = 1.2"Mix" = 42} Note: You will need to download and install the ToneLib-GFX software to use the preset.
