HardSoundCrunchee Preset name: metalHardSoundImpulse2 Effects chain: Spoiler: Preset settings Effect: "Noise Reducer" (Dynamics / Filter), active - "yes" { "Sens" = 75"Mode" = Soft} Effect: "T-Scream" (Overdrive / Distortion), active - "no" { "Drive" = 0"Tone" = 80"Level" = 40} Effect: "Slo 100" (Amp simulators), active - "yes" { "Gain" = 45"Bass" = 60"Middle" = 60"Treble" = 70"Presence" = 55"Master" = 60"Level (dB)" = 2} Effect: "IR Processor" (Cabinets), active - "yes" { "IR" = IR_HardSound"Low Cut (Hz)" = 87"Hi Cut (kHz)" = 20.0"Mix" = 100"Level (dB)" = 2} Effect: "Chorus St" (Modulation / Sfx), active - "no" { "Speed" = 2.8"Depth" = 42"Center" = 4.4"Mix" = 30} Effect: "TapeEcho" (Delay), active - "yes" { "Time" = 350"Feedback" = 38"Tone" = 65"LoDamp" = 19"Mix" = 23} Effect: "Room Rvb" (Reverb), active - "yes" { "Time" = 6.0"PreDelay" = 40"LoDamp" = 49"HiDamp" = 52"Mix" = 35} Effect: "AnalogDly" (Delay), active - "no" { "Time" = 447"Feedback" = 40"Tone" = 65"Mix" = 35} Note: You will need to download and install the ToneLib-GFX software to use the preset.
