Bohemian Rhapsody Solo Device: Zoom G5n Firmware: 3.00 Name on device: Rhapsody Optimized for: Phones/Speaker Effects chain: Patch comments: Bohemian Rhapsody - Queen. Brians Mays solo tone. Spoiler: Patch settings Effect: "ZNR" (Dynamics), active - "yes" "Detect" = GTRIN"Depth" = 32"Threshold" = 23"Decay" = 0 Effect: "TS Drive" (Overdrive / Distortion), active - "yes" "Gain" = 69"Boost" = Off"Tone" = 59"Volume" = 72 Effect: "UK 30A" (Amp simulator), active - "yes" "Bass" = 45"Treble" = 65"Cut" = 62"Gain" = 73"Volume" = 72"Depth" = 0"Speed" = 50"SOLO" = 3 Effect: "Gt GEQ 7" (Filter), active - "yes" "100 Hz" = -2.0"200 Hz" = 0.0"400 Hz" = 0.0"800 Hz" = 1.5"1.6 kHz" = -2.5"3.2 kHz" = -1.0"6.4 kHz" = -3.5"Volume" = 80"100 Hz" = 0.0"200 Hz" = 0.0"400 Hz" = 0.0"800 Hz" = 0.0"1.6 kHz" = 0.0"3.2 kHz" = 0.0"6.4 kHz" = 0.0"Volume" = 80"Parameter set" = A Effect: "UK2x12" (Cabinet), active - "yes" "MIC" = OFF"D57: D421" = 50"Hi" = 67"Lo" = 50 Effect: "Air" (Reverb), active - "yes" "Size" = 19"REF" = 5"Mix" = 35"Tail" = Off Effect: "Plate" (Reverb), active - "yes" "PreD" = 9"Decay" = 44"Mix" = 11"Tail" = Off Patch Volume: 90 DSP Load: 73% Note: This is a patch file, you will need to download and install the ToneLib-Zoom software to use the patch.
You can freely remove "UK2x12" (Cabinet) and then it's up to you, first I would be try to remove "ZNR" and if there is to much noise (because of UK 30A amp sim) and ZNR is required then remove less dominant of reverbs ("Plate" perhaps)