Factory [030]: SMR400 Set Device: Zoom B3n Firmware: 2.00 Name on device: SMR400 Set Optimized for: Phones/Speaker Effects chain: Patch comments: Using SMR400 and SMR4x10TW, this go-to-patch emphasizes high and low frequencies. Spoiler: Patch settings Effect: "160 Comp" (Dynamics), active - "yes" "Threshold" = -10"Ratio" = 4.0"Knee" = HARD"Volume" = 79 Effect: "Bass BB" (Overdrive / Distortion), active - "no" "Gain" = 57"Bass" = 3"Treble" = 1"Volume" = 36 Effect: "Kick FLNG" (Modulation), active - "no" "PreD" = 14"Depth" = 31"Rate" = 35"Resonance" = 73"Mix" = 61"RST-F" = 50"ON/OFF" = LATCH"LFO" = RESET Effect: "SMR400" (Amp simulator), active - "yes" "Bass" = 7.0"MID-F" = 300Hz"Middle" = 3.5"Treble" = -0.5"Gain" = 36"ENHNC" = 13"Volume" = 66"SOLO" = 3 Effect: "SMR4x10TW" (Cabinet), active - "yes" "DYN20" = 48"DYN57" = 80"Bottom" = 55"Balance" = 100 Patch Volume: 60 DSP Load: 70% Note: This is a patch file, you will need to download and install the ToneLib software to use the patch.