/ Register

Input Signal Level barely reacting to the input slider (on left of FX chain).

Discussion in 'General discussion' started by Wavelength, Jun 13, 2024.

  1. Jun 13, 2024 #1
    Wavelength

    Wavelength New Member

    Hi Members,

    I have Tonelib GFX loaded on a track in my DAW (Reaper). The input signal meter inside Tonelib GFX (the colored bar meter - on left side of FX chain) is not reacting to any changes when I move the input slider up or down. It barely registers anything except for a slight flicker at the very bottom of the meter (well below the -24db range on the slider marker).

    The audio Interface I am using is a Focusrite Scarlett 2i4 2nd Generation and I have the Gain Knob on the Focusrite set to about 10 oclock. I lowered the gain as well with no affect. I have the preset titled, "Blue Wind" loaded however whatever preset I load it's still the same issue. Everything seems to sound as normal as I simply use my ears when adjusting the input slider knob. However, the meter is not reacting to anything when I move the input slider.. Any ideas why?

    Please see screen shot of ToneLib GFX interface. I snapped the screenshot a millisecond after striking my guitar and you can see the input meter barely registers (please see RED circle and RED arrow in photo below/attached).

    Thank you very much Tonelib GFX Input Level Meter Not Responding.jpg
     
    Emily Thompson likes this.
  2. Jun 13, 2024 #2
    Wavelength

    Wavelength New Member

    Forgot to mention ... this issue occurs in either standalone mode or as a VST plugin.

    Regards
     
    Emily Thompson likes this.
  3. Aug 10, 2024 #3
    thefunnyside

    thefunnyside Member

    That's right. I can confirm.
    It seems to work in Tonelib-Metal though.
     
    nudiecrudi likes this.
  4. Aug 10, 2024 #4
    thefunnyside

    thefunnyside Member

    There is no support. You can reach them but you never get a reply.
    New releases are done under the hood and no longer advertized, and you never know what's been fixed. And more often, many bugs reported here are never fixed.
    I personaly cannot recommend this software.
     
  5. Aug 11, 2024 #5
    thefunnyside

    thefunnyside Member

    These are the risks of proprietary software.
    They can attract new comers with discounted prices and people will almost never complain because it was so cheap that it's not worth complaining. Smart.

    I once got a discount for Reamp ($20) from AudioAssault, and a good price for upgrading to Reamp2. Very worth it and with good support.
     
  6. Feb 2, 2025 #6
    blnamop

    blnamop New Member

    I met the same sh*t after update to 4.8.1 and, after, to 4.8.7. System win10, problem not depends on audio device and drivers.
    Some time I didn't remove 4.7.8 because it worked fully properly, but now I, supposing that this is reason of problem, uninstall 4.7.8 and messed up this way.
    I purchased it 5 years ago, found it was really woth of it. Note that price was almost same, not "discounted"
    Support doesn't pespond.

    nudlecrudi, better use amp Level knob or otput level slider. "Master" can emulate power amp ovedrive:)
     
    Last edited: Feb 2, 2025
Welcome to ToneLib Community Forum! Please take a moment and Register today!