No cab VibroDevice: Zoom G1on Firmware: 1.21 Name on device: VIBROnocab Optimized for: Phones/Speaker Effects chain: Patch comments: Roll of your volume and it'll clean up nicely with lots of headroom and a subtle tremolo effect, very responsive to picking/strumming technique. You can add a cab to add a different "color" /EQ. Or try a similar approach with a different amp I used a T style guitar with single coils, and the patch was made for headphone use. Master level on my unit is set on 30 Spoiler: Patch settings Effect: "FD VIBRO" (Amp simulators), active - "yes" "Gain" = 82 "Tube" = 74 "Level" = 120 "Trebl" = 45 "Middl" = 50 "Bass" = 55 "Prese" = 35 "CAB" = OFF "OUT" = LINE Effect: "GraphicEQ" (Dynamics / Filter), active - "yes" "160Hz" = 7 "400Hz" = 3 "800Hz" = 0 "3.2kHz" = 0 "6.4kHz" = -7 "12kHz" = 0 "Level" = 100 Effect: "Tremolo" (Modulation / Sfx), active - "yes" "Depth" = 25 "Rate" = 35 "Level" = 122 "Wave" = TRI 1 Effect: "Plate" (Delay / Reverb), active - "yes" "PreD" = 10 "Decay" = 30 "Mix" = 45 "Color" = 66 "LoDMP" = 97 "HiDMP" = 95 "Tail" = Off "Level" = 100 Effect: "Air" (Delay / Reverb), active - "yes" "Size" = 20 "Tone" = 8 "Mix" = 60 "Ref" = 5 "Level" = 100 "Tail" = OffPatch Volume: 70 Note: This is a patch file, you will need to download and install the ToneLib software to use the patch.