pull me under solo Device: Zoom G5n Firmware: 3.00 Name on device: pullmeSolo Optimized for: Phones/Speaker Effects chain: Patch comments: PULL ME UNDER SOLO Spoiler: Patch settings Effect: "TS Drive" (Overdrive / Distortion), active - "yes" "Gain" = 18"Boost" = Off"Tone" = 56"Volume" = 56 Effect: "Recti ORG" (Amp simulator), active - "yes" "Mode" = VNTG"Bass" = 66"Middle" = 64"Treble" = 58"Presence" = 79"Gain" = 76"Volume" = 63"SOLO" = 1 Effect: "BGN4x12" (Cabinet), active - "yes" "MIC" = ON"D57: D421" = 43"Hi" = 67"Lo" = 42 Effect: "Gt GEQ" (Filter), active - "yes" "160 Hz" = -1.5"400 Hz" = 3.5"800 Hz" = 3.0"3.2 kHz" = 4.5"6.4 kHz" = -1.5"12.0 kHz" = -2.0"Volume" = 69"160 Hz" = 0.0"400 Hz" = 0.0"800 Hz" = 0.0"3.2 kHz" = 0.0"6.4 kHz" = 1.5"12.0 kHz" = 4.0"Volume" = 85"CH SEL" = LATCH"Parameter set" = A Effect: "Hold DLY" (Delay), active - "yes" "Time" = Quarter x2"F.B." = 40"HiDMP" = 10"Tone" = 100"Mix" = 35"P-P" = P-P"Tail" = Off"Hold" = LATCH Effect: "Plate" (Reverb), active - "yes" "PreD" = 9"Decay" = 45"Mix" = 19"Tail" = Off Patch Volume: 60 DSP Load: 85% Note: This is a patch file, you will need to download and install the ToneLib software to use the patch.