WAH patch

Discussion in 'Zoom G1/G1X Four' started by Arpad, Mar 8, 2021.

  1. Arpad

    Arpad New Member

    WAH patch
    [​IMG]
    Device: Zoom G1X Four
    Firmware: 2.00

    Name on device: WAH
    Optimized for: Guitar Amp

    Effects chain:
    [​IMG]

    Patch comments:
    So far this is one of the best pathes for WAH I have came up with, first post. Let me know if it works.

    Effect: "BlackWah" (Pedal), active - "yes"
    "Frequency" = 50
    "Range" = 45
    "Dry" = 45
    "Volume" = 80

    Effect: "Comp" (Dynamics), active - "yes"
    "Sense" = 2
    "Attack" = Slow
    "Tone" = 7
    "Volume" = 80

    Effect: "MS 800" (Amp simulator), active - "yes"
    "Input" = LO
    "Bass" = 65
    "Middle" = 77
    "Treble" = 55
    "Presence" = 80
    "Gain" = 80
    "Volume" = 96

    Effect: "MS4x12" (Cabinet), active - "yes"
    "MIC" = ON
    "D57: D421" = 67
    "Hi" = 50
    "Lo" = 50

    Effect: "Hall" (Reverb), active - "yes"
    "PreD" = 70
    "Decay" = 10
    "Mix" = 54
    "Tail" = On
    Patch Volume: 100
    DSP Load: 65%


    Note: This is a patch file, you will need to download and install the ToneLib-Zoom software to use the patch.
     
    Last edited: Mar 9, 2021
  2. omegaprime

    omegaprime New Member

    where is the download file
     
  3. Arpad

    Arpad New Member

    Sorry I deleted the file accidentally, here is the patch, I replaced the compressor for a ZNR this time. I use this effect with an overdrive pedal but it sounds good just as it is as well.
     

    Attached Files:

    GrahamJRG likes this.
  4. StefanoJeff

    StefanoJeff New Member

    Hi tried right now!!! Very clean and warm tone!! it increases also the sensitivity of pedal thanks to the right bias between range and dry sound! Good job well done
     
    baz likes this.